科创中国

通过对三相异步电机功率因数控制器的工作原理分析,找出双向晶闸管的输出电压与其可控角之间的关系,提出了将功率因数控制器对晶闸管控制角控制计算转换为对时间控制的新控制算法.分析触发时间与输出电压之间的关系及触发方法,电机负载、功率因数与节能之间的关系,提出了功率因数控制器控制算法的两种控制方案,给出了控制算法程序框图,使单片机的软件设计实施方案更加方便.

Now the optimization strategies for power distribution are researched widely,and most of them are aiming to the optimal fuel economy and the driving cycle must be preknown.Thus if the actual driving condition deviates from the scheduled driving cycle,the effect of optimal results will be declined greatly.Therefore,the instantaneous optimization strategy carried out on-line is studied in this paper.The power split path and the transmission efficiency are analyzed based on a special power-split scheme and the efficiency models of the power transmitting components are established.The synthetical efficiency optimization model is established for enhancing the transmission efficiency and the fuel economy.The identification of the synthetical efficiency as the optimization objective and the constrain group are discussed emphatically.The optimization is calculated by the adaptive simulated annealing(ASA)algorithm and realized on-line by the radial basis function(RBF)-based similar models.The optimization for power distribution of the hybrid vehicle in an actual driving condition is carried out and the road test results are presented.The test results indicate that the synthetical efficiency optimization method can enhance the transmission efficiency and the fuel economy of the power-split hybrid electric vehicle(HEV)observably.Compared to the rules-based strategy the optimization strategy is optimal and achieves the approximate global optimization solution for the power distribution.The synthetical efficiency optimization solved by ASA algorithm can give attentions to both optimization quality and calculation efficiency,thus it has good application foreground for the power distribution of power-split HEV.

It is a common phenomenon that the cracks originating from a hole can cause structural damage in engineering.However,the fracture mechanics studies of hole edge crack problems are not sufficient.The problem of an elliptical hole with two collinear edge cracks of unequal length in an infinite plate under uniform tension at infinity is investigated.Based on the complex variable method,the analytical solutions of stress functions and stress intensity factors are provided.The stress distribution along the axes and the edge of the elliptical hole is given graphically.The numerical results show that there is obvious stress concentration near the hole and cracks,and the stresses tend to applied loads at distances far from the defect,which conform to Saint-Venant's principle.Hence,the stress functions are proved to be right.Under special conditions,the present configuration becomes the Griffith crack,two symmetrical cracks emanating from an elliptical hole,two cracks of unequal length emanating from a circular hole,a crack at the edge of a circular hole,or a crack emanating from an elliptical hole.Compared with available results,stress intensity factors for these special shapes of ellipses and cracks show good coincidence.The stress intensity factor for two cracks of unequal length at the edge of an elliptical hole increases with the crack length and the major-to-minor axis ratio of the elliptical hole.The stress distribution in an infinite plate containing an elliptic hole with unsymmetrical cracks is given for the first time.

The idle time which is part of the order fulfillment time is decided by the number of items in the zone; therefore the item assignment method affects the picking efficiency. Whereas previous studies only focus on the balance of number of kinds of items between different zones but not the number of items and the idle time in each zone. In this paper, an idle factor is proposed to measure the idle time exactly. The idle factor is proven to obey the same vary trend with the idle time, so the object of this problem can be simplified from minimizing idle time to minimizing idle factor. Based on this, the model of item assignment problem in synchronized zone automated order picking system is built. The model is a form of relaxation of parallel machine scheduling problem which had been proven to be NP-complete. To solve the model, a taboo search algorithm is proposed. The main idea of the algorithm is minimizing the greatest idle factor of zones with the 2-exchange algorithm. Finally, the simulation which applies the data collected from a tobacco distribution center is conducted to evaluate the performance of the algorithm. The result verifies the model and shows the algorithm can do a steady work to reduce idle time and the idle time can be reduced by 45.63% on average. This research proposed an approach to measure the idle time in synchronized zone automated order picking system. The approach can improve the picking efficiency significantly and can be seen as theoretical basis when optimizing the synchronized automated order picking systems.

目的表皮干细胞是组织工程化皮肤的"种子细胞".文中研究碱性成纤维细胞生长因子(basic fibroblast growth factor,bFGF)、胰岛素样细胞生长因子-1(insulin-like growth factor-1,IGF-1)和转化生长因子仅(transforming growth factor a,TGFa)对人表皮干细胞增殖的影响.方法采用两步酶消化法和Ⅳ型胶原差速贴壁相结合的方法获得人原代表皮干细胞,将表皮干细胞分为A组(K-SFM)、B组(K-SFM+bFGF)、C组(K-SFM+IGF-1)及D组(K-SFM+TGFot)进行培养.比较不同组之间表皮干细胞的克隆形成率、生长增殖、生长曲线和细胞周期等指标.结果B组、C组及D组培养的表皮干细胞在细胞增殖、细胞克隆率方面检测结果均明显高于A组(P〈0.05);流式细胞仪检测B组、C组与A组及D组处于G0/G1细胞比例比较差异有统计学意义(P〈0.05).结论IGF-1、bFGF及TGF-a均对表皮干细胞的增殖有促进作用,IGF-1及bFGF对表皮干细胞表型的维持有较好的作用.

对河北省石津灌区总千渠闸门控制系统构建的重要性和必要性进行了分析,针对灌区具体情况提出了闸控系统的设计原则,选择了主从结构、分布式实时监测方式,闸门的控制选择了现地控制、远程监测模式,可以实现多重控制手段来保证系统安全有效的运行.文章对系统进行了详细的总体设计,并分别阐述了现地监控站的结构组成、闸控系统应实现的功能和软件的性能、可实现功能等内容.总结了系统建设经验和今后系统运行维护时的重点,为同类型灌区提供了一定的经验和借鉴.

Majority of non-Newtonian fluids are pseudoplastic with shear-thinning property,which means that the viscosity will be different in different parts of the stirred tank.In such mixing process,it is difficult to predict accurately the power consumption and mean shear rate for designing novel impeller.Metzner-Otto method is a widely accepted method to solve these questions in mixing non-Newtonian fluids.As a result,Metzner-Otto constant will become a key factor to achieve an optimum way of economical mixing.In this paper,taking glycerine and xanthan gum solutions as research system,the power consumption,stirred by the impeller composed of perturbed six-bent-bladed turbine(6PBT)with differently geometrical characteristics in a cylindrical vessel,is studied by means of computational fluid dynamics(CFD).The flow is modeled as laminar and a multiple reference frame(MRF)approach is used to solve the discretized equations of motion.In order to determine the capability of CFD to forecast the flow process,the torque test experiment is used to measure the glycerine solution power consumption.The rheological properties of the xanthan gum solutions are determined by a Brookfield rheometer.It is observed that the power consumption predicted by numerical simulation agrees well with those measured using torque experiment method in stirring glycerine solution,which validate the numerical model.Metzner-Otto constant is almost not correlated with the flow behavior index of pseudoplastic fluids.This paper establishes the complete correlations of power constant and Metzner-Otto constant with impeller geometrical characteristics through linear regression analysis,which provides the valuable instructions and references for accurately predicting the power consumption and mean shear rate of pseudoplastic fluids in laminar flow,comparatively.

通过梳理搜索算法中出现的各种特征因子,提出一种更全面的特征因子分类方法,按其自身特点将特征因子划分为6类,分别是文字内容特征、Web拓扑特征、主题分布特征、文档类型特征、统计特征和时效性特征,并描述各特征项对主题相关性的作用、综合运用各类特征的通用化链接优先级计算公式以及特征选取原则.

针对当前交叉口信号灯模糊控制器结构参数固定的缺陷,提出了一种新的分级模糊控制器用于交叉路口交通流的控制与优化,该控制器能有效地减少规则数,易于提取模糊规则,能够显著改善交叉路口的通行能力.仿真实验结果证明该模型是有效的.

基于节能减排的目的,对中央空调控制系统实施改造.首先分析了中央空调系统的运行现状,阐述了中央空调系统的构成和变频节能原理,继而采用PLC和变频控制相结合的温差法控制方案对原有系统进行改造,给出了设计方案,进行了变频器的参数设置,并进行了节能分析.最后指出了中央空调采用变频调速控制具有较好的实用价值和发展前景.