Cavitation of centrifugal blood pump is a serious problem accompany with the blocking failure of short inlet cannula.However,hardly any work has been seen in published literature on this complex cavitation phenomenon caused by the coupling effect of inlet cannula blocking and pumps suction.Even for cavitation studies on ordinary centrifugal pumps,similar researches on this issue are rare.In this paper,the roles of throttling,rotation speed and fluid viscosity on bubble inception and intensity in a centrifugal blood pump are studied,on the basis of experimental observations.An adjustable throttle valve installed just upstream blood pump inlet is used to simulate the throttling effect of the narrowed inlet cannula.The rotation speed is adjusted from 2 600 r/min to 3 200 r/min.Glycerin water solutions are used to investigate the influences of kinetic viscosity.Bubbles are recorded with a high-speed video camera.Direct observation shows that different from cavitation in industrial centrifugal pumps,gas nuclei appears at the nearby of vane leading edges while throttling is light,then moves upstream to the joint position of inlet pipe and pump with the closing of the valve.It's found that the critical inlet pressure,obtained when bubbles are first observed,decreases linearly with viscosity and the slope is independent with rotation speeds;the critical inlet pressure and the inlet extreme pressure which is obtained when the throttle valve is nearly closed,fall linearly with rotation speed respectively and the relative pressure between them is independent with rotation speed and fluid viscosity.This paper studies experimentally on cavitation in centrifugal blood pump that caused by the failure of assembled short inlet cannula,which may beneficial the design of centrifugal blood pump with inlet cannula.
- 中国机械工程学报
文章来源： 万方数据
